|
|
Post by Northy on Jan 15, 2006 14:57:06 GMT
Has anyone any instructions for a Carbon tub car?
Cheers
G
|
|
|
|
Post by chris burgess on Jan 16, 2006 10:08:39 GMT
you might strike lucky if you ask Peter Ellis. He's on here quite often, and has more pred stuff than you can shake a big stick at.
|
|
|
|
Post by PeterEllis on Jan 17, 2006 20:18:50 GMT
I have them saved in a safe place, if anyone wants them e-mailing - I have the whole manual in a compressed folder of 47.7mb or page by page for 3mb (approx) each. There are 20 pages plus screw chart in the original manual. I don't have a TTech 95 manual - if anyone does ...  |
|
|
|
Post by PeterEllis on Jan 17, 2006 20:21:03 GMT
One tip for the actual tub is that TTech reccomended drilling the lower front gearbox right through and then using cap head screws secured with M3 nyloc nuts on the inside of the gearbox (instead of the self tap screws) - the rear seems to survive as std with self tap screws.
|
|
|
|
Post by Northy on Jan 17, 2006 21:01:49 GMT
Good tip Peter, the front gearbox is loose on the car I have, but not the back!  |
|
|
|
Post by Cooper on Jan 17, 2006 21:12:47 GMT
another tip I got for the carbon tub:
take some 24h epoxy and denatured alcohol, mix them up so you it's very liquid
strike your chassis with this and it will fill up the holes/scratches
clean it first ofcourse ! and test on a non visible place or old piece of carbon
|
|
