|
|
Post by hated1racing on Nov 30, 2006 19:52:28 GMT
are the kit sway bars supposed to fit extremely tight into the carbon piece? i am not getting fluid movement on the rear arms in the new kit build up and wondering if anyone sands the slot in the carbon piece so the sway bar is freed up a little. any help or thoughts or suggestions would be great!......
POSTED IN wRONG SECTION SORRY.
|
|
|
|
Post by chris burgess on Nov 30, 2006 20:24:04 GMT
dont worry about posting in the wrong section...it don't matter too much around these parts!  make sure you have the rear carbon plat on the right way round, and that your sway bar is sitting in the purposely cut-out groove. As long as this is the case, then the sway will have movement. You should aslo check o make sure the chromed lugs that the roll bar goes through on the wishbones are straight too - they can move when you tighten them up. make sure the hole in these lugs "follow" the direction of the sway bar, if you see what i mean. |
|
|
|
Post by hated1racing on Dec 2, 2006 3:16:45 GMT
thanks. the 'groove' was just too narrow and the sway bar fit in too tight causing binding. i sanded it out a little bit and it is all free now.
|
|
